By Ibel Perez, owner of Super Diver 911
This is a guide, plain and simple: a list of what you are most likely going to need to dive sidemount — the equipment that is required, in general, no matter whose name is on it. Everything on this list can be adjusted to fit you — your size, your water, your kind of diving. After the general list, we show you the exact list of NEX equipment we carry that fills it, piece by piece, and then the honest pros and cons of using ours versus anybody else’s.
One thing before the list: sidemount is a specialty. You need your basic certification first, and then a sidemount course — NAUI and PADI both teach one — before you dive this rig on your own. The course teaches tank handling, regulator switching, and gas planning. This guide handles the other half: the gear, so you walk into that course with the right kit.
The Required List, in General
Whatever brand you end up buying, a complete sidemount kit has these parts. Skip one, and the system does not work the way it is taught:
A sidemount rig — a harness, a spine (the backbone piece the harness is built on), and a bladder (the inflatable air cell that gives you lift). This is what holds the tanks at your sides.
Two first stages — one per tank. Each tank gets its own complete, independent regulator. That independence is the safety heart of sidemount.
Two second stages — one you breathe as your main, one as your backup, worn on a necklace under your chin.
Five hoses — a long hose for your main regulator, a short hose for the backup, two short high-pressure hoses, and an inflator hose for the bladder. The exact lengths are below.
Two pressure gauges — one per tank, no exceptions. Sidemount gas planning means watching both tanks.
Small hardware — a bungee necklace, bolt snaps, D-rings, and tank rigging (the bands and clips that hang a tank at each side).
That is the whole requirement. Sizes, hose lengths, and lift all adjust to you — a warm-water diver with one aluminum tank needs less than a cold-water diver with two steel tanks, and the list below shows both.
The Same List, in NEX — the Gear We Have
Here is the equipment we carry at Super Diver 911 that fills every line of that list.
The rig. The harness, spine, and bladder are covered in detail in our sidemount guide. Short version: the Hammerhead Spine Kit ($104.99) is the backbone, the Leatherback Harness (DIR $110.00 or padded Original $180.00) is what you wear, and the Hammerhead Bladder gives you lift — 16 lbs ($269.99) for one aluminum tank in warm water, 36 lbs ($449.99) for steel tanks, two tanks, or cold water. Everything below hangs off that rig.
The first stages: two Monterey Originals. The first stage we build this kit on is the NEX Monterey Original, from $549.99 — two of them, one per tank. Here is why it fits sidemount so well:
Balanced diaphragm. Your breathing effort stays the same from a full tank to an empty one, at any depth. In sidemount you are constantly switching between two tanks at different pressures, so consistent breathing from both sides matters more here than anywhere.
4 low-pressure ports and 2 high-pressure ports — the Original configuration. That is exactly what a sidemount side needs, with room to spare, as the port map below shows.
A swivel turret. The top of the first stage rotates, so your hoses can point the way sidemount routing wants them instead of fighting you.
Your choice of sealed or unsealed. Diving Florida’s springs, wrecks, or anywhere silty or cold? Order them environmentally sealed. Warm, clear ocean only? Unsealed is fine and costs less.
Here is what plugs into each Monterey — the same on both sides, with two differences noted:
Right-side Monterey (the long-hose side):
Low-pressure port 1: your main second stage, on the 7-foot long hose
High-pressure port 1: the right pressure gauge, on a short 6-inch hose
The remaining ports stay capped — one is your future drysuit hose port if you ever go dry
Left-side Monterey (the backup side):
Low-pressure port 1: your backup second stage, on the short 24-inch hose
Low-pressure port 2: the inflator hose to your bladder, about 22 inches
High-pressure port 1: the left pressure gauge, on a short 6-inch hose
The remaining ports stay capped
Shopping for the gear in this guide?
See the exact gear this post talks about in our shop — family-owned, free U.S. shipping, and we match and beat any authorized dealer’s discount.
👉 Shop the gear at superdiver911.com
The second stages: two, set up two ways. You need two second stages — we recommend the Balanced Adjustable 2.0 at $279.99 each, or the Balanced 2.0 from $254.99 each if you want to save and skip the adjustment knob. They are set up differently on purpose:
Right side — the long hose. This is the regulator you breathe most of the dive, and the one you hand to a buddy who is out of air. The 7-foot hose gives you both room to share air and still swim.
Left side — the necklace. This second stage rides on a bungee necklace (a simple cord loop) right under your chin, on its short 24-inch hose. If your main regulator ever fails, your backup is already at your mouth — no searching, no reaching.
Our NEX second stage guide compares every model if you want the deeper read.
The hose list — five hoses, exact lengths. This is the part new sidemount divers ask about most, so here it is plainly. A complete two-tank sidemount setup uses five hoses:
Low-pressure regulator hose, 84 inches (7 feet) — one. Right first stage to your main second stage. This is the long hose, the air-sharing hose.
Low-pressure regulator hose, 24 inches — one. Left first stage to your backup second stage on the necklace. Short on purpose — it goes straight to your chin and nowhere else.
High-pressure hose, 6 inches — two. One from each first stage to its pressure gauge. Short keeps the gauges tucked close where you can glance down and read them.
Low-pressure inflator hose, about 22 inches — one. Left first stage to your bladder’s inflator, so you can add air to the bladder without letting go of anything important.
That is 3 low-pressure hoses and 2 high-pressure hoses, total. A sixth hose — a drysuit inflator hose — only joins the list if you dive a drysuit.
Every hose on this list is one we build to order: our custom low-pressure hoses start at $60.46 and our custom high-pressure hoses start at $49.03. You pick the exact length, the fittings, and the colors — so order the lengths above, not whatever happens to be on a shelf.
The gauges: two — one per tank, no exceptions. You need two pressure gauges (SPGs) — one on each first stage, reading its own tank. This is not optional and it is not a place to save money. Sidemount gas planning means breathing both tanks down evenly, switching regulators as you go, and that only works if you can see both tank pressures at all times. One gauge cannot watch two tanks. The short 6-inch hoses keep both gauges clipped up near your chest D-rings, where a glance down reads them.
The small hardware. Short list, all of it cheap, all of it necessary: a bungee necklace for the backup regulator, bolt snaps for clipping the long hose and gauges, D-rings on the harness for the tank clips (our fixed and drop D-rings live in the shop), and tank rigging — the bands and clips that let you hang a tank at each side, including rental tanks when you travel. Your sidemount instructor will help you set the hardware positions in the course; that fitting session is part of the training.
NEX vs. Anybody Else — the Honest Pros and Cons
You can fill this same list with other brands, and plenty of divers do. Here is the straight comparison, the way we would want it told to us.
Where NEX wins:
One maker for the whole kit. The rig, the regulators, and the hoses all come from one brand and one shop. No mixing three companies’ parts lists and hoping they play well together — and one phone call if anything needs service.
Hoses built to your exact lengths. Sidemount lives and dies by hose routing. The big brands’ boxed sets give you the hose lengths they picked. Ours are built to order — the 84, the 24, the two 6s — in your fittings and your colors.
The total price. Add up the full kit below and compare it to a big-name sidemount package. Two complete NEX regulator sets plus the rig land well under what the famous technical brands charge for the same job.
Warranty and service. The regulators carry a 5-year warranty, and the shop that sells them to you services them — built to your order and pressure-tested for 24 hours before they ship.
Where the other brands win — honestly:
They sell a boxed sidemount package. The big technical brands will sell you a regulator set labeled “sidemount,” with the hoses already picked and in the box. NEX does not box it that way — you pick each piece yourself. This guide is the help for that picking, but it is more decisions up front.
The Monterey is a general-purpose first stage. It works beautifully in sidemount — the swivel turret and the 4-and-2 port layout are why we build on it — but it was not designed only for sidemount. A few sidemount-only first stages have an extra bottom port built in for the cleanest downward hose routing. On the Monterey, that routing runs off the turret — and if you ever want the extra port, NEX makes a 5th Port Kit for it.
Fewer divers know the name — yet. NEX is a smaller, newer brand than the giants. If you travel somewhere remote, a local shop is more likely to stock the big brands’ parts than NEX parts. Carry your spare kit when you travel, the way technical divers already do.
Our honest take: if you want a box that decides everything for you, the big brands sell that box, for more money. If you want the kit fitted to you — your hose lengths, your colors, your water — for less, with a 5-year warranty behind it, that is exactly what this list builds.
What the Whole Kit Costs
Two-tank rig (36 lbs bladder, spine, Original harness): $734.98
Two Monterey first stages: from $1,099.98
Two Balanced Adjustable 2.0 second stages: $559.98
The five hoses, custom-built: from $279.44
Total: from $2,674.38 — plus your two gauges and small hardware
Warm-water single-tank version: swap in the 16 lbs bladder and DIR harness and the rig drops to $484.98, for a total from $2,424.38.
Building it over time? Buy in this order: rig first, then the two first stages, then the second stages, then the hoses and gauges together (the regulators cannot be set up without them), and the trim pocket and back pouch last, when your diving asks for them.
Your regulators carry a 5-year warranty, are built to your order, and are pressure-tested for 24 hours before they ship. The rig pieces carry a 2-year store warranty. Everything ships free in the U.S., and we match and beat any authorized dealer’s discount.
Not ready to buy yet? Join free for gear tips and the monthly special: superdiver911.com/membership
Questions about any of this gear? Call or text us at (754) 444-2431, or visit superdiver911.com. We are a family-owned dive shop, and a real diver answers.
Support the little guy — shop with a family-owned dive shop.
Super Diver 911 is a small, family-owned dive shop. When you buy from us instead of a big-box store, you keep real dive shops alive — the shops that train divers, service gear, and keep this sport personal. Visit our website, browse the gear, and reach out any time: we match and beat any authorized dealer’s discount, and shipping is free anywhere in the U.S.
Let’s help the little guy — support the family-owned dive shops. They’re the heart of this sport.